wiring technique on Bonsai
Quick answer
If your Bonsai has wiring technique, the most likely cause is: Aluminum wire is the preferred starting wire for bonsai due to its soft, malleable properties that bend easily by hand without heat treatment.
Start here:
- 1. 1. Select aluminum wire diameter equal to approximately 1/3 of branch thickness being trained
- 2. 2. Cut wire length to span the full section to be shaped plus 20% extra for anchoring
Why Bonsai gets wiring technique
Aluminum wire is the preferred starting wire for bonsai due to its soft, malleable properties that bend easily by hand without heat treatment.
How to reverse wiring technique on Bonsai
- 1
1. Select aluminum wire diameter equal to approximately 1/3 of branch thickness being trained
- 2
2. Cut wire length to span the full section to be shaped plus 20% extra for anchoring
- 3
3. Anchor wire firmly at base (in soil or around trunk) before wrapping up the branch
- 4
4. Wrap at 45-degree spiral angle with even spacing—each wrap touches the previous at about 1 wire diameter
- 5
5. Bend branch immediately after wiring while the aluminum supports the movement
- 6
6. Check wire monthly; remove before it bites into bark as the branch thickens
Keep wiring technique off this Bonsai
Use aluminum wire for deciduous species and beginners. Select diameter approximately 1/3 branch thickness. Apply at 45-degree angle with 1-2 wire-diameter spacing.